Magnolia Blossoms Craft Project

How to make a Magnolia Blossom from Latex Balloons

Supplies Needed

18 gauge craft wire (must be 18 gauge)
this is available at craft stores such as Hobby Lobby, however if you do not have a craft store available, you can buy 18 gauge wire in a small roll at a hardware store.

package of 9" or 11" helium quality latex balloons

floral stem wrapping tape

magnolia center

at least three magnolia leaves - (silk leaves are fine)

wire cutters

scissors

glue gun (maybe)

Cut 9 pieces of 18 gauge wire into 18" pieces

Cut 4 pieces of 18 gauge wire into 9" pieces

Fold the 18" pieces in half, leaving rounded at the top

Cut the ends off of 9 ballons

Feed the folded 18" wires into the 9 balloons

Pull balloon down tight to the end of the wire, this part of the process is difficult and takes patience

Wrap the balloon very tightly with the floral tape

Continue wrapping all nine balloons and wires with floral tape

Now pull the wires out inside the balloons and shape the petals.

This is why you need 18 gauge wire, so it will hold it's shape.

Fasten one 9" wire to the magnolia center, this may require using the glue gun to get it to stay.

If you do not have a magnolia center, you can purchase them at a craft store, but they are pricey.

Place three petals around the magnolia center, and wrap with floral tape

Add three additional petals, and wrap with floral tape

Add three remaining petals, and wrap with floral tape

Add at least three magnolia leaves, and wrap with floral tape

There you have it, one gorgeous magnolia blossom, created from latex balloons

Thanks to Dona at Admiralty RV Park in San Antonio TX for teaching me this craft.

If you enjoyed this project and would like to see more, add your email address at the top of the page.  You will only receive updates from this blog, and can unsubscribe at any time.